Brake Parts

Actuating Lever - R.H., made by Tekonsha

Shoe and Lining Kit (wheel set)forAlko 10" x 2 1/4" made by Tekonsha

*Light Green wires. Length -3 1/8. Width - 2. Thickness - 15/16. Fits or Replaces *AL-KO Kober10 x2 1/4

Actuating Lever - R.H., made by Tekonsha

Shoe and Lining Kit (wheel set)forAlko 12" x 2" made by Tekonsha

*White wires. Length -3 1/8. Width - 2. Thickness - 15/16. Fits or Replaces *AL-KO Kober 12 x 2 6K & 7K

Rust proof heavy duty Polymer case to protect battery and charger from elements and corrosion U-shaped clamp style fastener to mount over most trailer tongues 1 bolt installation on Jack post or A-frame

Charger for battery (part #620008)

Side post adapters for General Motors Sold as a pair

* Cadmium plated isolator with terminal nuts and lock washers. 3 terminal isolator for metal frame ground systems. Isolates starting battery *Provides secondary battery current for auxiliary power. Full time charge on both batteries

* Cadmium plated isolator with terminal nuts and lock washers *4 terminal has insulated ground terminal for use with fiberglass or other non-conductive materials. Isolates starting battery *Provides secondary battery current for auxiliary power. Full time charge on both batteries

Battery Box and Hardware for The Engager Break-away systems

* Includes backing plate shoe and lining, magnets, and actuating lever. Adjusting screw and spring hardware units come completely assembled. L.H.ALKO Assembly - 12" x 2

Standard break away switch. 7" wires

Fully digital settings for power level (gain) with built in time ramp Easy to read digital power scale from 5% to 99% Innovative vertical slide is easier to see and use than traditional horizontal slides Braking capacity: Up to4 trailer brakes Mounts at a angle (no leveling required) Short proof protected Lifetime warranty

All vehicle specific brake control wiring harnesses are available in 2-Plug styles 2-Plug units are designed for brake controls that have a wiring port built into the back of unit Simply plug the brake control end of the wiring harness into the back of the brake control and the vehicle end into the automobile's port Brake controls that utilize the 2-plug style of wiring harness will be identified with the Plug & Play logo BP1 - under or behind the dash, to the left or right of the emergency brake pedal BP2 - under or behind the dash, to the left of the steering column and brake pedal BP3 - under or behind the dash to the right of the steering column and brake pedal BP4 - kick panel area, on the driver's side BP5 - under or behind dash, behind the center console BP6 - under or behind dash on the passenger side, near glovebox BP7 - centered behind dash between the steering column and the radio